Fujitsu SPARC T5440 Bedienungsanleitung PDF herunterladen (Seite 179)

Returning the Server to Operation 153

▼ Connect the Power Cords to the Server

● Reconnect both power cords to the power supplies.

Note – As soon as the power cords are connected, standby power is applied.

Depending on the configuration of the firmware, the system might boot. See the

SPARC Enterprise T5440 Server Administration Guide for configuration and power-on

information.

▼ Power On the Server

● To power on the server, do one of the following:

■ To initiate the power-on sequence from the service processor prompt, issue the

poweron command.

■ You will see an -> Alert message on the system console. This message

indicates that the system is reset. You will also see a message indicating that the

VCORE has been margined up to the value specified in the default.scr file

that was previously configured.

■ Example:

■ To initiate the power-on sequence manually, use a pen or pencil to press the

Power button on the front panel. See “Front Panel Diagram” on page 3 for

Power button location.

Note – If you are powering on the server following an emergency shutdown

triggered by the top cover interlock switch, you must use the poweron command.

-> start /SYS

1 2 ... 174 175 176 177 178 179 180 181 182 183 184 ... 213 214

Keine Kommentare

Fujitsu SPARC T5440 Bedienungsanleitung Seite 179