Fujitsu SPARC T5120 Bedienungsanleitung PDF herunterladen (Seite 192)

166 SPARC Enterprise T5120 and T5220 Servers Service Manual • July 2009

FIGURE: Installing a Power Supply in a SPARC Enterprise T5120 Server

8. Install the motherboard assembly.

See “Install the Motherboard Assembly” on page 120.

Note – After replacing the power distribution board and powering on the system,

you must run the ALOM CMT setcsn and setcpn commands to set the

electronically readable chassis serial number and server part number.

9. At the ALOM CMT command line interface, use the setcsn command to set the

chassis serial number and the setcpn command to set the server part number

on the power distribution board.

The following is an example of the command-line dialog used to set the chassis

serial number and server part number for a SPARC Enterprise T5120 server.

1 2 ... 187 188 189 190 191 192 193 194 195 196 197 ... 239 240

Keine Kommentare

Fujitsu SPARC T5120 Bedienungsanleitung Seite 192