Fujitsu ST6012 Betriebsanweisung PDF herunterladen (Seite 64)

- User-Installable Features

To remove the battery from the Tablet PC:

2 Slide the battery release latches in the direction indicated. (See Figure 13.)

3 Pull the battery away from the system, as shown in the illustration and remove the battery from the Tablet PC.

If you are using an external battery charger, refer to the instructions provided with the battery charger.

To install the battery:

1 Orient the battery with the slides in the empty battery tray. Slide the battery into the tray and press it firmly until

it is seated. When it is properly seated, the battery release latches will return to position and lock the battery.

2 Once the battery is installed, you can resume system operation or start and use your system normally.

1 Choose one of the following:

• If a charged battery is available, you can

suspend system operation. A built-in

“bridge” battery will maintain the system

in Sleep mode for about 5 minutes while

the battery is removed; this allows time

for replacement with a charged battery.

• If a charged battery is not available, save

your work and close all running programs,

then shut down the system or Hibernate.

• Plug in an external DC power source.

Figure 13. Removing the battery

NDER FEDERAL, STATE, OR LOCAL LAW, IT MAY BE ILLEGAL TO DISPOSE OF BATTERIES BY PUTTING

THEM IN THE TRASH. BE SURE TO DISPOSE OF BATTERIES IN ACCORDANCE WITH LOCAL GOVERNMENT

REGULATIONS.

Release latch

Battery

ST6000.book Page 64 Monday, November 3, 2008 10:23 AM

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 131 132

Keine Kommentare

Fujitsu ST6012 Betriebsanweisung Seite 64