Fujitsu ST6012 Betriebsanweisung PDF herunterladen (Seite 51)

- Starting the Tablet PC

To suspend system operation:

1 Slide the Suspend/Resume switch, or carry out the Sleep command from your operating system or power

management program. (If your system is configured to suspend operation using Hibernate mode, which is

explained later in this procedure, a message is displayed while data is saved to your hard disk.)

2 The Power icon either flashes (Sleep) or is not displayed (Hibernate) when system operation is suspended,

depending on how your system is configured. At this point, programs that were running are stopped, active data

is saved, and the system enters one of two different low-power states, or sleep modes, as explained in the

following paragraphs.

3 Observe the Power icon in the Status display to determine which suspend mode your system is using.

• Power icon is blinking: Sleep mode.

In this mode, active data is saved by maintaining power to RAM while most other system

components are powered off. The Battery Gauge icon in the Status display indicates the battery

charge level.

• Power icon is not displayed: Hibernate mode.

In this mode, active data is stored on the hard disk drive and power usage is reduced to the same

level used in the Off state. When the system is in Hibernate mode, the Battery Gauge icon is not

visible in the Status display. In this mode, there is no danger of losing data if battery power is lost.

If you have successfully performed this procedure, system operation is now suspended. Refer to

“Resuming System Operation” later in this chapter to resume system operation. Also, note the

following with regard to suspending system operation:

IF YOU ARE REPLACING THE BATTERY, WAIT UNTIL SYSTEM OPERATION IS SUSPENDED AND THE POWER

ICON IS FLASHING BEFORE YOU REMOVE THE BATTERY. FAILURE TO DO SO COULD RESULT IN LOSS OF

YOUR UNSAVED DATA. (NOTE THAT IF THE RESUME ON LAN FUNCTION IS ENABLED IN THE BIOS

SETUP, YOU SHOULD NOT REMOVE THE BATTERY UNLESS THE SYSTEM IS SHUT DOWN. WHEN RESUME

ON LAN

IS ENABLED, THE BRIDGE BATTERY IS DISABLED IN ORDER TO OPTIMIZE BATTERY LIFE.)

ST6000.book Page 51 Monday, November 3, 2008 10:23 AM

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 131 132

Keine Kommentare

Fujitsu ST6012 Betriebsanweisung Seite 51