Fujitsu Fi-6240 Bedienungsanleitung PDF herunterladen (Seite 9)

fi-6140/fi-6240 Image Scanner Getting Started 4

■

Connecting with the USB Cable

1. Connect the USB cable to the USB connector.

2. Connect the other end of the USB cable to the PC.

■

Connecting with the SCSI Cable

When using the scanner with a SCSI interface, the following

SCSI cable and SCSI card must be purchased.

• SCSI cable:

Use a cable which complies with a 50 Pin Contact

Shielded High-Density SCSI Device Connector for

Ultra SCSI.

• SCSI card:

Find the recommended SCSI card information in the

Fujitsu web site (FAQ).

http://imagescanner.fujitsu.com/

1. Insert the SCSI cable into the SCSI connector of the

scanner until both sides click.

2. Connect the other end of the cable to your

computer.

■

Setting the SCSI ID

The factory initial setting for SCSI ID is [5].

1. Press the Power button at least for two seconds to

turn off the scanner.

2. Set the SCSI ID using the SCSI ID switch on the

back of the scanner.

3. Press the Power button to turn on the scanner.

When the scanner is turned ON, the SCSI ID set at

Step 2 is enabled.

ATTENTION

• Be sure to use the USB cable which comes as an

accessory with this scanner.

Scanning operation with commercially available cables is

not guaranteed.

• When connecting to an USB hub, use the first stage USB

hub that is closest to the computer. If you use the second

or later hub stages, the scanner may not operate

correctly.

• If you connect the scanner with USB 2.0, it is required

that the USB port and Hub are compliant with USB 2.0.

The scanning speed may slow down if it is connected

with USB1.1.

ATTENTION

• After connecting the SCSI cable, turn the scanner on.

• In a SCSI daisy chain formation, connect the scanner so

that it is the terminated device.

ATTENTION

Be careful not to bend the pins of the SCSI connector when

connecting to the scanner.

HINT

The SCSI ID initially set at the factory is [5]. If the SCSI ID of

another SCSI device is set to the same ID, either change the

scanner's SCSI ID or SCSI ID of the other SCSI device. For

details on how to change the SCSI ID, refer to "Setting the

SCSI ID" in this section (D page 4).

ID No. Description

0 to 7

Can be set as the ID

8, 9

Works with the factory default value

(SCSI ID = 5).

Click

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare

Fujitsu Fi-6240 Bedienungsanleitung Seite 9

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Scanner Fujitsu Fi-6240