Fujitsu XG0448 Bedienungsanleitung PDF herunterladen (Seite 44)

XG0448 Hardware Guide Chapter 2 Installation

Connecting a Setup PC

Prepare a Setup PC

Log on using the terminal software.

1. Start up the terminal software by using the set up PC.

2. Set the setting conditions to the following;

Please refer to the terminal software manual for instructions on setting conditions.

3. Press [Return] key or [Enter] key.

Precautions

The following message may appear When pressing the [Return] key or [Enter] key. In such case, the switch is

processing another job, and waiting for such process to finish. Please wait for a moment until it finishes such process.

Waiting for completion of the other operation...

4. Confirm “Login :” on screen.

5. Key in “admin” and press [Return] key or [Enter] key.

6. Confirm “Password:” on screen.

7. Key in password, then press the [Return] key or [Enter] key.

Since password is not set at the initial state, simply press [Return] key or [Enter] key without keying in the password.

If the password is already set, key in the password. Then press [Return] key or [Enter] key.

8. Confirm “#” is shown on screen

If the key in the wrong password, "invalid password." will be displayed, then the "Login :" will be displayed again. Please

repeat your process from item 5.

Item Setting

Start Bit 1

Data Bit 8

Parity Bit n/a

Stop Bit 1

Synchronous System Asynchronous Communication System (Start-Stop Communication System)

Communication Speed 9600

Flow Control None

Number of digits on screen 80 (If other than 80 digits, set it through terminal command)

Number of rows on screen 24 (If other than 24 rows, set it through terminal command)

1 2 ... 39 40 41 42 43 44 45 46 47 48 49

Keine Kommentare

Fujitsu XG0448 Bedienungsanleitung Seite 44