Fujitsu DESKPOWER 2000 Bedienungsanleitung

iDESKPOWER 2000 Series User’s ManualFujitsu endeavours to ensure that the information in this document is correct,but accepts no liability for any err

xConventionsThe following are the conventions used in this manual:Text entered by user Represents text input by the user. Screen messages Denotes actu

xitable of contentsChapter 1 SYSTEM BOARD1.1 MAINBOARD FEATURES ... 31.2. MAINBOARD LAYO

xiiChapter 2 AWARD® BIOS SETUP2.1 ENTERING SETUP ... 152.2 GETTING HELP ...

She_Chp1_01-10 11/3/00, 11:051

2INTRODUCTIONThe DESKPOWER 2000 is a high-performance computer based on Intel® 810chipset. The board is designed for the Intel® Pentium III (FC-PGA) a

31.1 MAINBOARD FEATURESCPU• Support Socket370 for Intel® Pentium III and CeleronTM processor.Chipset• Intel® 810 (GMCH/GMCH0) chipset. (421 BGA)- Inte

4On-Board Peripherals• On-Board Peripherals include:- 1 floppy port supports 1 FDD with 720K and 1.44Mbytes.- 1 serial port (COMA)- 1 parallel port su

51.2. MAINBOARD LAYOUTDESKPOWER 2000 MainboardPCI SLOT 3PCI SLOT 2PCI SLOT 1ATXPower SupplyIntel810chipset(GMCH)Socket 370DIMM 2Top:mouseBottom:keyboa

6t I/O Ports ConnectorUSB USB port.IDE1 For Primary IDE port.IDE2 For Secondary IDE port.PS/2 For PS/2 Keyboard / Mouse port.FDD For Floppy port.COMA

71.4 CLEAR CMOS JUMPER: JBAT1/J26A battery must be used to retain the mainboard configuration in CMOS RAM. Short1-2 pins of JBAT1/J26 to store the CMO

iiIMPORTANT SAFETYINSTRUCTIONS1. Read these instructions carefully. Save these instructions for future reference.2. Follow all warnings and instructio

81.4.1 BIOS FLASH JUMPER: JP3This jumper is used to locked/unlocked BIOS Flash. This Jumper should be unlockwhen flashing/programming the BIOS.BIOS Fl

91.4.2 CPU CORE SPEED DERIVATION PROCEDUREThe mainboard CPU Bus Frequency can be set through BIOS setupDefault setting enables auto detection of CPU s

101.5 MEMORY INSTALLATION1.5.1 MEMORY BANK CONFIGURATIONThe mainboard supports a maximum memory size of 256MB(64-bit technology): Itprovides two 168-p

111.6 ONBOARD AUDIO ENABLED/DISABLEDJUMPER: JP4This jumper is used to Enabled/Disabled the onboard audio.Enabled Disabled1133JP413She_Chp1_11-13 11/3/

121.7 CD-IN CONNECTOR: J8This connector is for CD-ROM audio connector.CD_InLGND RShe_Chp1_11-13 11/3/00, 11:0512

131.8 EXPANSION CARDS1.8.1 INSTALLING A PCI CARDTo install a PCI card:1. Locate the PCI slot(s) on the slot board.2. Remove the bracket on the housing

14She_Chp2_14-38 11/3/00, 11:0514

15AWARD® BIOS SETUPAward® BIOS ROM has a built-in Setup program that allows users to modify thebasic system configuration. This type of information is

162.3 THE MAIN MENUOnce you enter Award ® BIOS CMOS Setup Utility, the Main Menu (Figure 2-1) willappear on the screen. The Main Menu allows you to se

17• Standard CMOS setupUse this Menu for basic system configurations.• Advanced BIOS FeaturesUse this menu to set the Advanced Features available on y

iii10. If an extension cord is used with this product, make sure that the total ampererating of the equipment plugged into the extension cord does not

18CMOS Setup Utility - Copyright(C) 1984-1999 Award SoftwareStandard CMOS SetupDate (mm:dd:yy) : Fri, Feb 28, 1999Time (hh:mm:ss) : 00 : 00 : 00IDE Pr

19• DateThe date format is <day> <month> <date> <year>.Day Day of the week, from Sun to Sat, determined by BIOS.Read-only.mont

202.5 ADVANCED BIOS FEATURESCMOS Setup Utility - Copyright(C) 1984-1999 Award SoftwareAdvanced BIOS FeaturesItem HelpMenu Level >Anti-Virus Protect

21• External CacheChoose Enabled or Disabled. This option enables the level 2 cache memory.• CPU L2 Cache ECC CheckingChoose Enabled or Disabled. This

22• Typematic Rate SettingKey strokes repeat at a rate determined by the keyboard controller. Whenenabled, the typematic rate and typematic delay can

232.6 ADVANCED CHIPSET FEATURESThe Advanced Chipset Features Setup option is used to change the values of thechipset registers. These registers contro

24• SDRAM CAS latency TimeWhen synchronous DRAM is installed, the number of clock cycles of CASlatency depends on the DRAM timing. The settings are: 2

25• Delayed TransactionThe chipset has an embedded 32-bit posted write buffer to support delaytransactions cycles. Select Enabled to support complianc

262.7 INTEGRATED PERIPHERALSCMOS Setup Utility - Copyright(C) 1984-1999 Award SoftwareIntegrated PeripheralsItem HelpMenu Level >OnChip Primary PCI

27• OnChip Primary/Secondary PCI IDEThe integrated peripheral controller contains an IDE interface with support fortwo IDE channels. Select Enabled to

ivStarting your PCfor the first timeShe int _i-xv 11/3/00, 11:054

28• IDE HDD Block ModeBlock mode is also called block transfer, multiple commands, or multiplesector read/write. If your IDE hard drive supports block

29• Onboard Parallel ModeSPP : Standard Parallel PortEPP : Enhanced Parallel PortECP : Extended Capability PortTo operate the onboard parallel port as

30• IPCA FunctionThis item allows you to enabled/disabled the Advanced Configuration AndPower Management (ACPI).The settings are: Enabled and Disabled

31Min. Power Saving Minimum power management.Suspend Mode = 1hr., and HDD Power Down = 15min.Max. Power Saving Maximum power management — SuspendMode

32• Wake-Up by PCI CardThis will enable the system to wake up through PCI Card peripheral.The settings are : Enabled and Disabled.• Power on by RingTh

33RELOAD GLOBAL TIMER EVENTSReload Global Timer events are I/O events whose occurrence can prevent thesystem from entering a power saving mode or can

34• Reset Configuration DataNormally, you leave this field Disabled. Select Enabled to reset ExtendedSystem Configuration Data (ESCD) when you exit Se

352.10 FREQUENCY/VOLTAGE CONTROLThis section is for setting CPU Frequency/Voltage Control.CMOS Setup Utility - Copyright(C) 1984-1999 Award SoftwareFr

362.11 LOAD FAIL-SAFE/OPTIMIZED DEFAULTS• Load Fail-Safe DefaultsWhen you press <Enter> on this item, you get a confirmation dialog box with ame

372.12 SET SUPERVISOR/USER PASSWORDYou can set either supervisor or user password, or both of them. The differencesare:Supervisor password : can enter

vStarting your PC for the first timeBooting the SystemWhen you turn on your PC for the first time, it will display a Fujitsu logo on thescreen. If you

38Fujitsu PC (Asia) Pte Ltd200 Pandan Loop#05-03 Pantech 21The Computer CentreSingapore 128388Tel: 65-776 0688Fax: 65-776 0788Fujitsu PC (Asia) Pte Lt

viLicense AgreementRead the license agreement carefully. You can scroll through the text using themouse to activate the scroll bar or use the up arrow

viiTime ZoneWhen your PC has completely identified all of the installed hardware, it will displaya dialog box entering which time zone you wish to set

viiiB. Software Drivers and ApplicationYou will find a Composite CD packet in your accessories box. Please store thepacket in a safe place in case the

ixAbout this manualShe int _i-xv 11/3/00, 11:059